A solution to excessive fire in a kiln ?

1. When the fire is too fierce, we can adjust the density of the upper part of the billet stack according to the suction force of the kiln fan.
2. It is also possible to make sure that most of the input coal falls to the bottom of the kiln and does not stay on the top of the billet stack in the eye of fire.
3. When the fire is too fierce in the kiln, we can raise the air brake, shorten the preheating zone appropriately and lengthen the roasting zone.
4. When the fire is too large, the upper fire can be pulled down through the near-lift air brake. When the bottom fire reaches 3-4 rows of fire, the upper fire can be restored to the normal use of the brake.
5. The length of each belt of the kiln should be adjusted reasonably.It can also be improved by changing the kang leg code method.It can also adjust the opening of the smoke brake in time, appropriately improve the near brake, reduce the far brake.
In this paper, the contents of a detailed to introduce the when the kiln in the fire too hard, we should adopt what method can quickly and thoroughly solved, because the suitable temperature for the quality of the finished goods is very important, when the temperature is too high or too low, is likely to affect burning products, and even burn out.Therefore, we must pay attention to the control of the temperature of the kiln when we use it in the future.